Supported Cameras

This page gives a complete list of cameras supported, cameras not listed are not supported.

Canon Cameras

The following table shows all Canon cameras supported.

Screen Shot 2019-03-31 at 6.21.56 PM.png


*Mirror Lockup: Where possible the software lifts the mirror with a short delay before releasing the shutter to reduce the risk of vibration during image capture.

** 5DS / 5DS R / 1D X Mark II / 5D Mark IV / 6D Mark II / 7D Mark II / 80D: MultiPoint Focus Test will not work with these cameras. Fully supported and working for automatic focus calibration, focus consistency and other tests with center focus point.

Wide and Tele Calibration: Some Canon cameras have the ability to record two calibration values when used with zoom lenses. This function exists on EOS-1D X, EOS-1D X Mark II, EOS 5D Mark III, EOS 5D Mark IV, EOS 5DS, EOS 5DS R, EOS 6D, EOS 6D Mark II, EOS 7D Mark II, EOS 70D and EOS 80D. If the camera is capable of two calibration values on single lens FoCal is able to use this feature (calibrate each zoom lens twice, once at either zoom extreme and FoCal will adjust the correct setting on the camera).

Nikon Cameras

The following table shows all Nikon cameras supported by FoCal, their available features as well as their FoCal Mode.

Screen Shot 2019-03-31 at 6.22.18 PM.png

*Mirror Lockup: Where possible FoCal lifts the mirror with a short delay before releasing the shutter to reduce the risk of vibration during image capture.

Not Supported (Sony / Pentax / Panasonic etc)

Support for a wider range of cameras is something we continue to investigate. Both Nikon and Canon make available a software library that we use to control these cameras. This type of software control is slowly starting to become possible for other cameras and when it does you can be sure we will be looking accommodate them.